Learn how to Remove and replace a Faucet - Local Plumbing Company Gold River

Maybe youíve been curious on how to replace a faucet at one point. It isnít as hard as you may have thought. A few hours and some basic tools are all it takes. When properly changed, a new faucet eliminates water leaks or drips that you may have had with the old faucet. It also improves the look of your sinks. The guide below shows you how.

Step 1 - Shut off Water Supply

Turn off the water supply to the sink. Shutoff valves are generally found beneath the sink. Older houses are unlikely to have shutoff valves. Should this be the case, youíll must shut down the main shutoff valve at the point of entry to the house. The valve may be located outside. Trace the cold water pipe until you reach a socket marked with ìWî. Use a socket wrench to turn off the water.

Step 2 - Clear Beneath the Sink

Youíre likely to have stuff in storage in the area below the sink. It is a good idea to put these items elsewhere temporarily. This allows you to work efficiently.

Step 3 - Light Up

Place a portable lamp or drop light in the area below the sink. You need lots of light to help you work efficiently.

Step 4 - Detach the Faucet

You will find 2 big tubular screws behind the sink that secure the faucet against the sink. Water supply tubes run through these nuts. Use a basin wrench to loosen the nuts on the faucet. If your faucet has a spray head and hose, disconnect the nut that secures the hose. As you disengage the water supply tubes from the faucet, water will drain back from the faucet. Absorb the water with an old towel. Stand at the sink and lift the detached faucet out of the sink. Keep it aside.

Step 5 - Clean

Dirt is likely to have build up where the faucet was installed to the sink. Remove the dirt with a putty knife. Wipe the area clean with a damp cloth. For stubborn particles, use some white vinegar to clear stains.

Step 6 - Install New Faucet

Use some plumberís putty around the faucet base if it wasnít supplied with gaskets. If the new faucet has a squirt head, run the hose through the allowance on the faucet, then through the sink. Attach to the supply stub. Install the faucet to the sink. Attach nuts and tighten partially by hand. Examine the faucet to make sure whether it's well aligned. If gaskets are used, ensure theyíre also correctly aligned. You may then proceed to tighten the nuts completely using the basin wrench.

Step 7 - Inspect

Turn on the water supply. When you observe any leaks, youíll have to tighten the fittings more securely. Otherwise, everything should be okay.

Tip:

It is advisable to replace your water supply lines when you replace the faucet. Take one with you to the hardware store so that you can get 2 tubes in the length. Remove the old tubes and put in the new ones securely. However, if the tubes are in good shape, replacement wonít be necessary.
Local Plumbing Service & Repair Company El Dorado Hills